74*245 Motor Driver

H-Bridge Driver

Simple PWM Gen.

Handy Method Measuring RPM

Measuring RPM via Photo reflector

Introduction to Robotic

DC, Stepper,and Servo Motor

Microcontroller Tutorial

Computer Interface
Tutorial
.............more links

BACK

Software Line Follower Robots Microcontroller 8051:
Software for write to AT89C2051 is robot1.hex ,which was written by C-language ,the source code is robot1.c compiled by using MIDE-51, you can download this compiler from here.

#include 8051io.h #include 8051reg.h extern register unsigned char speedleft,speedright; register unsigned char high,low,flag,time;

main()
    {
           P1=0x40;
           P3=0xff;
           high = 80;
           low = 30;
           flag = 0;
           time = 50;
           Start();
           while(1) {
           P3|= 0x0f;
           Run();
           }
           }

Start()
           {
           char exit,key;
           exit =1;
           while(exit)
           {
           key = P1;
           if((key & 0x40)==0) exit=0;
           }
           } 

Run()
           {
           char sensors;
           sensors = (P3 &=0x0f);

 if((sensors & 0x01)==0) {
           TurnRight();
           flag = 1; }

 else if((sensors & 0x08)==0) {
           TurnLeft();
           flag = 2; }
           else if(sensors == 0x09) {
           Forward(high);
           flag = 0; }

 else if(((sensors==0x0b)||(sensors==0x0d))&&(flag==0))
           Forward(low);

}

Forward(char speed)
           {
           P1=0x64;
           speedright = speed+10;
           speedleft = speed;
           delay(time);
           }

TurnRight()
           {
           P1=0x68;
           speedright = low+5;
           speedleft = low;
           delay(time);
           }

TurnLeft()
           {
           P1=0x54;
           speedright = low+5;
           speedleft = low;
           delay(time);
           }

Reverse(char speed)
           {
           P1=0x58;
           speedright = speed;
           speedleft = speed+5;
           delay(time);
           }

BACK