Pelatihan Mikrokontroller

Microcontroller Kits
Programmer and Target 89s51

Simple Mikrokontroller 89s51 Trainer


Standart
Mikrokontroller 89s51 Trainer


Super Mikrokontroller Trainer 89s51

All Kits

+
Programmer
Serial

BACK NEXT

2.6.3. Generating a Stair Step Voltage by Using Look Up Table

In this lesson we are like to design, how to generate stair step voltage from 0volt trough 5 volt, with resolution 0.5 volt each step. There is something you must to do is to calculate the konstanta K, as you have learned in previous lesson.

Step 1st
Build the circuit as shown in figure 2.6.2 As you seen on figure 2.6.2. P0.0 trough P0.7 is connected to A8 - A1.
For example, we assumes that the Vref = 5 volt, R14 = 5 k, and Rf = 5k

   K = Vref/ R14;
     = 5/5k
     = 1 mA
If, we put logic high into A1 through A8 then we have:
   Io = 1 mA x 0.99
      = 1 mA
So,Vo = Io x Rf
      = 1 mA x 5k
      = 5 volt
Voltage Resolution = 5/255 = 0.0196 volt

* Voltage 0 volt
      = 0/ 0.0196
      = 0 decimal 
* Voltage 0.5 volt
      = 0.5/0.0196
      = 25 decimal
 * Voltage 1 volt
      = 1/0.0196
      = 51 decimal
* Voltage 1.5 volt
      = 1.5/0.0196
      = 76 decimal
      :
      :
* Voltage 5 volt
      = 5/0.0196
      = 255 decimal

Step 2nd
In this step, you must tipe the assembly program to make a voltage from your DAC, we assume that you have already known the editor, we used MIDE-51 to edit the program. ( Download File : exp263.zip , Download Complete Circuit File : DAC0808.pdf)

       org 0h
       mov DPTR,#DataDAC

start: clr A
       movc A,@ A+DPTR
       mov P0,A
       inc DPTR
       call delay
       sjmp start
       ;
delay: mov R0,#0
delay1:mov R2,#0fh
       djnz R2,$
       djnz R0,delay1
       ret
       ;
DataDAC:
       DB 0,25,51,76,102,127,153,178,204,229,255
       end

Step 3rd
Safe your assembly program above, and name it with dac3.asm (for example) Compile the program that you have been save by using MIDE-51, see the software instruction.

Step 4th
Download your hex file into the microcontroller by using Microcontroller ATMEL ISP software, see the instruction.After download this hex file you'll see the action of DAC ( of course if your cable connection and your program are corrected )

f.4. Generating a Sine Wave Voltage by Using Look Up Table

In this lesson we are like to design, how to generate sine wave voltage from 0volt trough 5 volt, with resolution 0.1 volt each step. There is something you must to do is to calculate the konstanta K, as you have learned in previous lesson. For this lesson you must to do by your self, something that gives you a clue is:

Figure 2.6.3. Sine wave voltage 0 - 5 volt

Comments, questions and discussion about this topic

BACK NEXT